Toyota Yaris: Oil Pump / Components
COMPONENTS
ILLUSTRATION
| *1 | FAN AND GENERATOR V BELT | *2 | ENGINE WIRE |
| *3 | NO. 2 AIR HOSE | *4 | ENGINE UNDER COVER RH |
| *5 | NO. 1 AIR TUBE | *6 | COMPRESSOR ASSEMBLY WITH PULLEY |
| *7 | NO. 1 ENGINE UNDER COVER ASSEMBLY | - | - |
 | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | TIMING GEAR COVER INSULATOR | *2 | CRANKSHAFT PULLEY |
| *3 | TIMING CHAIN COVER ASSEMBLY | *4 | TIMING CHAIN COVER OIL SEAL |
| *5 | OIL PUMP GASKET | *6 | SEAL WASHER |
| *7 | V-RIBBED BELT TENSIONER ASSEMBLY | - | - |
 | Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
 | N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part |
 | Adhesive 1344 |
 | MP grease | ★ | Precoated part |
| *T1 | 1st: 260 (2651, 192) 2nd: Turn 90° | - | - |
Oil Pump
..
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT WHEELS Click here
2. REMOVE ENGINE UNDER COVER RH Click here
3. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here
4...
Other information:
Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT BUMPER ASSEMBLY (a) Install the 3 grommets. HINT: Use the same procedure for the RH side and LH side. (b) Temporarily install the front bumper assembly with the 2 clips and 2 bolts. (c) w/ Pre-collision System: (1) Connect the connector...
Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Chassis
CHASSIS INSPECT STEERING LINKAGE AND GEAR HOUSING (a) Inspect the steering wheel free play. Click here (b) Inspect the steering linkage for looseness or damage. (1) Check that the tie rod ends do not have any play. (2) Check that the dust seals and boots are not damaged...
Categories
- Manuals Home
- Toyota Yaris Owners Manual
- Toyota Yaris Service Manual
- To Set Speed
- Starting the Engine
- Engine Start Function When Key Battery is Dead
- New on site
- Most important about car
Supplemental Restraint System (SRS) Precautions
The front and side supplemental restraint systems (SRS) include different types of air bags. Please verify the different types of air bags which are equipped on your vehicle by locating the “SRS AIRBAG” location indicators. These indicators are visible in the area where the air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag) The front passenger dashboard (front passenger air bag) The outboard sides of the front seatbacks (side air bags) The front and rear window pillars, and the roof edge along both sides (curtain air bags)