Toyota Yaris: Power Source & Network / Networking
INSTALLATION PROCEDURE 1. INSTALL GENERATOR WITH REGULATOR ASSEMBLY (a) Temporarily install the generator with regulator assembly. (b) Using an E8 "TORX" socket wrench, install the 2 stud bolts...
Other information:
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear trailing arm assembly removal/installation are shown below...
ComponentsCOMPONENTS ILLUSTRATION
*1 ROCKER PANEL MOULDING - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL HOUSE FRONT PLATE Click here
2...
Categories
If a key is left in the vehicle, the functions of the key left in the vehicle
are temporarily suspended to prevent theft of the vehicle.
To restore the functions, press the unlock button on the functions-suspended
key in the vehicle.
read more