Toyota Yaris: Owner Maintenance / Light Bulbs
Front
With Halogen Headlights
- Headlights (Low/High beam)/Daytime running lights
- Front side-marker lights
- Overhead lights/Map lights
- Side turn signal lights (if equipped)
- Front turn signal lights/Parking lights
- Fog lights (if equipped)
With LED Headlights
- Headlights (High beam)
- Headlights (Low beam)
- Front side-marker lights
- Overhead lights/Map lights
- Side turn signal lights (if equipped)
- Front turn signal lights/Parking lights
- Daytime running light/Parking light
- Fog lights
Rear
4-Door
- Trunk light
- High-mount brake lights
- License plate lights
- Reverse lights
- Rear turn signal lights
- Brake lights/Taillights/Rear side-marker lights
5-Door
- High-mount brake light
- License plate lights
- Reverse lights
- Rear turn signal lights
- Brake lights/Tail lights
- Rear side-marker lights
- Luggage compartment light
- To replace the bulb, contact your Toyota dealer.
- If the halogen bulb is accidentally touched, it should be cleaned with
rubbing
alcohol before being used.
- Use the protective cover and carton of the replacement bulb to dispose
of
the old bulb promptly out of the reach of children.
WARNING
Never touch the glass portion of a halogen bulb with your bare hands
and always wear eye protection when handling or working around the
bulbs
When a halogen bulb breaks, it is dangerous. These bulbs contain
pressurized gas. If one is broken, it will explode and serious injuries could be
caused by the flying glass.
If the glass portion is touched with bare hands, body oil could cause
the
bulb to overheat and explode when lit.
Always keep halogen bulbs out of the reach of children
Playing with a halogen bulb is dangerous. Serious injuries could be
caused
by dropping a halogen bulb or breaking it some other way.
NOTICE
When removing the lens or lamp unit using a flathead screwdriver, make
sure that the flathead screwdriver does not contact the interior terminal. If
the flathead screwdriver contacts the terminal, a short circuit may occur.
Proper tire balancing provides the best riding comfort and helps
reduce tread wear. Out-of-balance tires can cause vibration and
uneven wear, such as cupping and flat spots...
Headlights/Daytime running lights (With halogen headlights)
Make sure the ignition is switched off, and the headlight switch is
off.
Lift the hood...
Other information:
INSTALLATION PROCEDURE 1. INSTALL AUTO HIGH BEAM SWITCH (a) Engage the claws to install the auto high beam switch as shown in the illustration.
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Click here
3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Click here
4...
PARTS LOCATION ILLUSTRATION
*1 FORWARD RECOGNITION CAMERA *2 FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY *3 BRAKE ACTUATOR ASSEMBLY - SKID CONTROL ECU *4 ECM ILLUSTRATION
*1 COMBINATION METER ASSEMBLY *2 STEERING SENSOR *3 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *4 POWER DISTRIBUTION BOX ASSEMBLY - ECU-IGR NO...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more