Toyota Yaris: Warning/Indicator Lights / Indicator Lights
These lights turn on or flash to notify the user of the system operation
status or a system malfunction.
KEY
Indicator Light
Wrench Indicator Light
TCS/DSC
Indicator Light
DSC OFF
Indicator Light
Low
Speed Pre-Collision System Indicator Light
Low
Speed Pre-Collision System OFF Indicator Light
Low
Engine Coolant Temperature Indicator Light
Shift
Position Indication
Headlight High-Beam Indicator Light
Turn
Signal/Hazard Warning Indicator Lights
Security Indicator Light
Cruise
Main Indication
Cruise
Set Indication/Indicator Light
Select
Mode Indicator Light
Lights-On Indicator Light
Front
Passenger Air Bag Deactivation Indicator Light
* 1: The light turns on when the ignition is switched on for
an operation check,
and turns off a few seconds later or when the engine is started. If the light
does not turn on or remains turned on, have the vehicle inspected at your
Toyota dealer.
These lights turn on or flash to notify the user of the system operation
status or a system malfunction.
Master
Warning Light
Brake
System Warning Light
ABS
Warning Light
Charging System Warning Light
Engine
Oil Warning Light
Check
Engine Light
High
Engine Coolant Temperature Warning Light
Automatic Transaxle Warning Light
Power
Steering Malfunction Indicator Light
Air
Bag/Front Seat Belt Pretensioner System Warning Light
LED
Headlight Warning Light
Low
Fuel Warning Light
Check
Fuel Cap Warning Light
Seat
Belt Warning Light (Front seat)
Door-Ajar Warning Light
Low
Washer Fluid Level Warning Light
Tire
Pressure Monitoring System Warning Light
KEY
Warning Light
Low
Speed Pre-Collision System Warning Light
* 1: The light turns on when the ignition is switched on for
an operation check,
and turns off a few seconds later or when the engine is started...
When the ignition is switched ON,
the wrench indicator light is illuminated and then turns off after a
few seconds.
The wrench indicator light is illuminated when the preset maintenance period
arrives...
Other information:
INSPECTION PROCEDURE 1. INSPECT TIE ROD END SUB-ASSEMBLY LH (a) Secure the tie rod end sub-assembly LH in a vise between aluminum plates. NOTICE: Do not overtighten the vise. (b) Install the nut to the stud bolt. (c) Flip the ball joint back and forth 5 times...
The side air bags are mounted in the outboard sides of the front
seatbacks.
When the air bag crash sensors
detect a side impact of greater
than moderate force, the system inflates the side air bag
only on the side in which the
vehicle was hit...