Toyota Yaris: G16e-gts (engine Mechanical) / Cylinder Head

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL NO. 3 OIL NOZZLE SUB-ASSEMBLY (a) Using a 5 mm hexagon wrench, install the 3 No. 3 oil nozzle sub-assemblies to the cylinder block sub-assembly with the 3 bolts...

Precaution

PRECAUTION HINT: Any digits beyond the 0.01 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only. When both standard and maximum or minimum values are listed for an inspection, use the standard value as a reference only and base any judgments on the maximum and minimum values...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Engine Immobiliser System Incorrect Assembly (B279C95)

DESCRIPTION If an ECM that is incompatible with the immobiliser function is installed, the ECM will store this DTC. DTC No. Detection Item DTC Detection Condition Trouble Area Note B279C95 Engine Immobiliser System Incorrect Assembly An ECM that is incompatible with the immobiliser function is installed...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP NOTICE: When installing a new roof drip side finish moulding clip, remove any double-sided tape remaining where the roof drip side finish moulding clips will be installed on the vehicle body and clean the vehicle body with a non-residue solvent...