Toyota Yaris: Heating / Air Conditioning / Air Conditioning Amplifier
Other information:
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
Dynamic Radar Cruise Control System
Lane Tracing Assist System
Front Radar Sensor System
Pre-collision System
Auto High Beam System
Triangle Target:
Flat Surface Target:
Driving Adjustment:
Update ECU security key Vehicle control history (RoB) are stored
PROCEDURE 1...
The hook positioned under the
rear bumper on the right side is for
tying down the vehicle during
transport, and it cannot be used
for towing other vehicles.
It can be used as a towing hook
only when the vehicle must be
towed by another vehicle in an
emergency case such as when
the vehicle is stuck in snow, however, it may damage the bumper...
Categories
Before refueling, close all the doors, windows, and the liftgate/trunk
lid, and switch the ignition OFF.
To open the fuel-filler lid, pull
the remote fuel-filler lid release.
To remove the fuel-filler cap, turn it counterclockwise.
Attach the removed cap to the
inner side of the fuel-filler lid.
read more