Toyota Yaris: Engine & Hybrid System / G16e-gts (fuel)
INSTALLATION CAUTION / NOTICE / HINT NOTICE: This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts...
Other information:
DESCRIPTION Problem Symptom Suspected Area Trouble Area
Engine does not crank
Engine cranks slowly
Auxiliary battery depletion
Starter malfunction
Starter system
Auxiliary battery depletion
Starter malfunction
Starter circuit
Excessive engine friction Engine Engine assembly
Starting time is long
Engine speed fluctuation due to abnormal combustion
Idle speed too low or high
The engine stalls immediately after starting
Strong engine vibration due to above symptoms
Ignition malfunction
Deviation in air fuel ratio (Excessive or insufficient intake air volume or fuel supply)
Insufficient compression
Changes in load from another system
Ignition system
Spark plug
Ignition coil assembly
Fuel system
Direct fuel injector assembly
Port fuel injector assembly
Fuel pump assembly (for high pressure side)
Fuel pump (for low pressure side)
Fuel pump control circuit
Fuel suction plate sub-assembly
Fuel main valve assembly
Fuel line
Purge VSV system
Fuel quality (existence of foreign matter, degradation)
Intake and exhaust systems
Mass air flow meter sub-assembly
Intake system
(Air leaks or deposit accumulation)
Throttle body with motor assembly
Air fuel ratio sensor (sensor 1)
Air fuel ratio sensor (sensor 2)
Cam timing oil control solenoid assembly
Variable Valve Timing system (VVT system)
Other control systems
ECM
Wire harness or connector
Knock control sensor
Engine coolant temperature sensor
Immobiliser system
Engine
Water control valve
Engine assembly
Crankshaft position sensor
High load from another system
Air conditioning system
Power steering system
Electrical load signal system
SYMPTOM AND CAUSE OF SYSTEM MALFUNCTION HINT: The following are descriptions of the characteristics of each system malfunction...
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH Click here
2. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side) Click here
3...
Categories
If a key is left in the vehicle, the functions of the key left in the vehicle
are temporarily suspended to prevent theft of the vehicle.
To restore the functions, press the unlock button on the functions-suspended
key in the vehicle.
read more